Skip to Content
Last modified by Alexander Mott on 2024/02/13 22:29
Show last authors
1 The Crestron ZUMNET-JBOX-DALI can be configured in two different modes.  App mode or Legacy mode (DIN-DALI-2 emulation).
2
3 (% class="box warningmessage" %)
4 (((
5 Minimum supported ZUMNET firmware version is PUF zum-wired_1.03.27.puf.
6 \\ShowRunner Version Minimum: 3.20
7 )))
8
9 (% style="margin-right:auto; width:800px" %)
10 |=Function|=APP Mode|=Legacy Mode
11 |Address and Group Fixtures|Zum App on Phone/Tablet|(((
12 * ShowRunnerCLC™ UI
13 * Toolbox DALI Commissioning Tool 2.0
14 * Console (same as DIN-DALI-2)
15 )))
16 |Lighting Logic|Internal to Zum Room, can be enhanced by showrunner|(((
17 ShowRunnerCLC™ only, same as DIN-DALI-2
18 )))
19 |showrunner Controller Type (Model)|(% style="width:350px" %)//ZUMNET-JBOX-DALI//|(% style="width:350px" %)//ZUMNET-JBOX-DALI-LEGACY//
20 |Configuration Steps|(% style="width:350px" %)(((
21 1. Update Firmware to 1.3.27 puf or later
22 1. Connect to ZUMNET-JBOX Console
23 1. Enter Command: //DALISETMODE 1 2//
24 1. Wait 5 seconds, ZUMNET JBOX should reboot, if not reboot
25 1. Enter Command: //ZWMODE ZUM//
26 1. Reboot
27 )))|(% style="width:350px" %)(((
28 1. Update Firmware to 1.3.27 puf or later
29 1. Connect to ZUMNET-JBOX Console
30 1. Enter Command: //ZWMODE CNET//
31 1. Reboot
32 1. Enter Command: //DALISETMODE 1 1//
33 1. Wait 5 seconds, ZUMNET JBOX should reboot, if not reboot
34 )))
35 |Known Issues|(((
36 * All fixtures/groups must be setup through the app.  If not done through the app then controls do not work from the app or showrunner.  There is no way to discover existing groupings.  Requires complete re-address and group.
37 * TEST button only controls defined groups and not broadcast (Crestron says they will revert this back to broadcast in a future release)
38 )))|