Skip to Content
Version 3.8 by Mark Kohlmann on 2022/09/19 21:12
Hide last authors
Mark Kohlmann 1.1 1 The Crestron ZUMNET-JBOX-DALI can be configured in two different modes.  App mode or Legacy mode (DIN-DALI-2 emulation).  Minimum supported firmware version is PUF zum-wired_1.03.27.puf.
2
3 (% style="margin-right:auto; width:800px" %)
4 |=Function|=APP Mode|=Legacy Mode
Mark Kohlmann 2.1 5 |Address and Group Fixtures|Zum App on Phone/Tablet|(((
Mark Kohlmann 1.1 6 * showrunner UI
Mark Kohlmann 2.1 7 * Toolbox DALI Commissioning Tool
8 * Console (same as DIN-DALI-2)
Mark Kohlmann 1.1 9 )))
Mark Kohlmann 2.1 10 |Lighting Logic|Internal to Zum Room, can be enhanced by showrunner|(((
11 showrunner only, same as DIN-DALI-2
Mark Kohlmann 1.1 12 )))
Mark Kohlmann 3.1 13 |showrunner Controller Type|(% style="width:350px" %)//ZUMNET-JBOX-DALI//|(% style="width:350px" %)//ZUMNET-JBOX-DALI-LEGACY//
Mark Kohlmann 2.1 14 |Configuration Steps|(% style="width:350px" %)(((
15 1. Update Firmware to 1.3.27 puf or later
16 1. Connect to ZUMNET-JBOX Console
17 1. Enter Command: //DALISETMODE 1 2//
18 1. Wait 5 seconds, ZUMNET JBOX should reboot, if not reboot
19 1. Enter Command: //ZWMODE ZUM//
20 1. Reboot
21 )))|(% style="width:350px" %)(((
22 1. Update Firmware to 1.3.27 puf or later
23 1. Connect to ZUMNET-JBOX Console
24 1. Enter Command: //ZWMODE CNET//
25 1. Reboot
26 1. Enter Command: //DALISETMODE 1 1//
27 1. Wait 5 seconds, ZUMNET JBOX should reboot, if not reboot
28 )))
29 |Known Issues|(((
30 * All fixtures/groups must be setup through the app.  If not done through the app then controls do not work from the app or showrunner.  There is no way to discover existing groupings.  Requires complete re-address and group.
31 * TEST button only controls defined groups and not broadcast (Crestron says they will revert this back to broadcast in a future release)
32 )))|