Skip to Content

Changes for page Crestron Command Line

Last modified by Craig Lewis on 2022/11/14 15:09
From version 2.1
edited by Craig Lewis
on 2021/07/12 17:27
Change comment: There is no comment for this version
To version 1.1
edited by Craig Lewis
on 2021/07/12 17:20
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -1,25 +1,9 @@
1 -Autodiscovery Query - scans network for all connected Crestron network devices
1 +Est - shows IP Configurations of connected device
2 2  
3 -Est - shows IP Configurations of connected device (same command as ipconfig)
3 +DHCP 0 off - turns DHCP off and allows users to set static IP Address
4 4  
5 -DHCP Administrator Enable/disable dynamic IP addressing
5 +IPA 0 x.x.x.x - to set static IP Address
6 6  
7 -IPAddress Administrator Set IP address
7 +IP 0 x.x.x.0 - to set IP Mask (typical mask is 255.255.255.0)
8 8  
9 -IPCONFIG Operator Display/Configure IP Settings
10 -
11 -IPMask Administrator Set IP Subnet Mask.
12 -
13 -IPTable Operator Display IP Table
14 -
15 -DEFRouter Administrator Set default router.
16 -
17 -
18 -ADDMaster Programmer Add a master entry to IP table
19 -
20 -REMMaster Programmer Remove a master entry to IP table
21 -
22 -
23 -ADDSlave  Programmer Add a slave entry to IP table
24 -
25 -REMSlave  Programmer Remove a slave entry to IP table
9 +DEFR 0 x.x.x.1 - to set Default Gateway