Skip to Content

Changes for page ZUM-HUB4 Processor Setup

Last modified by Craig Lewis on 2025/03/13 15:50
From version 24.1
edited by Alexander Mott
on 2022/10/19 18:00
Change comment: There is no comment for this version
To version 26.1
edited by Austin Weygandt
on 2023/05/12 22:05
Change comment: There is no comment for this version

Summary

Details

Page properties
Author
... ... @@ -1,1 +1,1 @@
1 -XWiki.alexander\.mott@chiefintegrations\.com
1 +XWiki.austin\.weygandt@chiefintegrations\.com
Content
... ... @@ -38,8 +38,8 @@
38 38  **** Set IP subnet mask: ##ipm 0 (% style="color:darkgoldenrod" %)**255.255.255.0**(%%)##
39 39  **** Set default gateway: ##defr 0 **10.0.0.1**##
40 40  **** Set hostname: ##host HUB4-CPP##
41 -**** If ZUMNET-JBOXs will be connected via the LAN port, set secure gateway: ##securegateway default ##
42 -***** (Note: this setting defines whether or not a secure connection is required on the LAN side of the control processor for Crestron devices)
41 +**** If ZUMNET-JBOXs or other non-secure Crestron devices such as 3-Series EISC will be connected via the LAN port, set secure gateway: ##securegateway default ##
42 +***** Note: this setting defines whether or not a secure connection is required on the LAN side of the control processor for Crestron devices
43 43  **** Reboot the processor: ##reboot##
44 44  *** If connecting lighting hardware to the Control Subnet port, then you may optionally configure the Control Subnet. If manually configuring the control subnet, we recommend the following IP range as it won't conflict with corporate networks:
45 45  **** Using the "Functions>Ethernet Addressing...>Control Subnet" menu of Toolbox:
... ... @@ -84,7 +84,7 @@
84 84  
85 85  * Connect your computer to the same network as the processor. Make sure your computer’s IP settings are compatible with the lighting network and do not conflict with any devices already on the network
86 86  * Connect to the ZUM-HUB4 in Crestron Toolbox
87 -** Run the "##ver##" and verify that the reported firmware is v2.7100.00016 or greater
87 +** Run the "##ver##" and verify that the reported firmware is v2.8000.00009 or greater (**NOTE**: older firmware will report the license as "Canvas Control" rather than "ZumHubProgramming" and will not work)
88 88  ** Open the Functions>License Management... window
89 89  *** If "ZumHubProgramming" license is listed with "Expiration: Never", then the license has already been activated and this step is not necessary
90 90  ** Navigate to the Functions>License Management...>Add License tab