Skip to Content
Last modified by Alexander Mott on 2024/12/02 19:02
From version 2.1
edited by Alexander Mott
on 2024/10/24 17:33
Change comment: There is no comment for this version
To version 2.3
edited by Alexander Mott
on 2024/10/24 17:38
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -1,4 +1,9 @@
1 -{{box cssClass="floatinginfobox" title="**CONTENTS**"}}{{toc/}}{{/box}}
1 +(% class="box floatinginfobox" %)
2 +(((
3 +{{toc/}}
4 +)))
5 +
6 +
2 2  Crestron Ethernet Control Modules are a group of Crestron devices that provide I/O ports (such as relay outputs and serial interfaces) via Ethernet connection to the processor. The most common devices are CEN-IO-COM-102 and CEN-IO-COM-202, which provide RS-232 and RS-485 serial ports for third-party integrations. All Ethernet Control Modules have models beginning with "CEN-IO", so that is how they will be collectively referred to throughout this article.
3 3  For SHOWRUNNER™ installations, the IP address of the CEN-IO does not matter as long as it is in the same range as the processor and does not conflict with any other devices on the network. Instead, CEN-IOs are identified to the processor via their IP-ID. Note that what cables are landed at which ports of the CEN-IO matters, and if connections are moved between ports or between modules then the configuration will need to be updated (see below). Chief Integrations typically provides an SRTakeoff.xlsx spreadsheet with an IP Table tab that lists all the CEN-IO IP-IDs in the program. If no takeoff is provided, then the processor's IP table can be checked by running the ##ipt -t ##command from the processor after the configuration is loaded.
4 4  
... ... @@ -44,7 +44,7 @@
44 44  * At this point, it is a good idea to [[update the device firmware>>doc:SHOWRUNNER™ Setup Guide.SHOWRUNNER™ Installation Guide.SHOWRUNNER™ Installation and Network Setup.Updating Firmware.WebHome]]
45 45  * Repeat for all CEN-IOs on the job
46 46  
47 -If setup has been done correctly and the ShowRunnerCLC™ program and configuration have already been loaded to the processor, then you should see the CEN-IO's IP-ID as online when you run the ##ipt## command on both the CEN-IO and the processor.
52 +If setup has been done correctly and the ShowRunnerCLC™ program and configuration have already been loaded to the processor, then you should see the CEN-IO's IP-ID reporting online when you run the ##ipt## command on both the CEN-IO and the processor.
48 48  
49 49  == Static Configuration ==
50 50  
... ... @@ -68,4 +68,4 @@
68 68  * At this point, it is a good idea to [[update the device firmware>>doc:SHOWRUNNER™ Setup Guide.SHOWRUNNER™ Installation Guide.SHOWRUNNER™ Installation and Network Setup.Updating Firmware.WebHome]]
69 69  * Repeat for all CEN-IOs on the job
70 70  
71 -If setup has been done correctly and the ShowRunnerCLC™ program and configuration have already been loaded to the processor, then you should see the CEN-IO's IP-ID as online when you run the ##ipt## command on both the CEN-IO and the processor.
76 +If setup has been done correctly and the ShowRunnerCLC™ program and configuration have already been loaded to the processor, then you should see the CEN-IO's IP-ID reporting online when you run the ##ipt## command on both the CEN-IO and the processor.