Skip to Content
Last modified by Alexander Mott on 2024/12/02 19:02
From version 2.1
edited by Alexander Mott
on 2024/10/24 17:33
Change comment: There is no comment for this version
To version 2.2
edited by Alexander Mott
on 2024/10/24 17:35
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -44,7 +44,7 @@
44 44  * At this point, it is a good idea to [[update the device firmware>>doc:SHOWRUNNER™ Setup Guide.SHOWRUNNER™ Installation Guide.SHOWRUNNER™ Installation and Network Setup.Updating Firmware.WebHome]]
45 45  * Repeat for all CEN-IOs on the job
46 46  
47 -If setup has been done correctly and the ShowRunnerCLC™ program and configuration have already been loaded to the processor, then you should see the CEN-IO's IP-ID as online when you run the ##ipt## command on both the CEN-IO and the processor.
47 +If setup has been done correctly and the ShowRunnerCLC™ program and configuration have already been loaded to the processor, then you should see the CEN-IO's IP-ID reporting online when you run the ##ipt## command on both the CEN-IO and the processor.
48 48  
49 49  == Static Configuration ==
50 50  
... ... @@ -68,4 +68,4 @@
68 68  * At this point, it is a good idea to [[update the device firmware>>doc:SHOWRUNNER™ Setup Guide.SHOWRUNNER™ Installation Guide.SHOWRUNNER™ Installation and Network Setup.Updating Firmware.WebHome]]
69 69  * Repeat for all CEN-IOs on the job
70 70  
71 -If setup has been done correctly and the ShowRunnerCLC™ program and configuration have already been loaded to the processor, then you should see the CEN-IO's IP-ID as online when you run the ##ipt## command on both the CEN-IO and the processor.
71 +If setup has been done correctly and the ShowRunnerCLC™ program and configuration have already been loaded to the processor, then you should see the CEN-IO's IP-ID reporting online when you run the ##ipt## command on both the CEN-IO and the processor.