Skip to Content

Changes for page Zūm Discovery

Last modified by Alexander Mott on 2025/04/03 17:35
From version 7.1
edited by Alexander Mott
on 2022/09/22 23:59
Change comment: There is no comment for this version
To version 8.1
edited by Alexander Mott
on 2022/09/23 00:00
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -36,7 +36,7 @@
36 36  1*. Set unique Connection IDs for each device hosted on the ZUMNET-JBOX so that their firmware can be updated
37 37  1*. Load the Zūm Wired firmware to the ZUMNET-JBOX
38 38  1*. Repeat the above steps for all ZUMNET-JBOXs
39 -1*. Once all the ZUMNET-JBOXs have pushed the new firmware to their hosted devices, proceed to the next step
39 +1*. Once all the ZUMNET-JBOXs have pushed the new firmware to their hosted devices, disconnect from them in Toolbox and proceed to the next step
40 40  1. Connect to first ZUMNET-JBOX in the Crestron Zūm App
41 41  1. Unique Connection IDs should be automatically assigned to any Zūm Link and Cresnet devices on the ZUMNET-JBOX
42 42  1*. If firmware was out-of-date, then this step should have already been completed
... ... @@ -48,7 +48,8 @@
48 48  1. Optionally, manually configure the ZUMNET-JBOX IP table to point at the processor if you want to keep track of which ZUMNET-JBOX is at each IP-ID
49 49  1*. If you do not manually configure the IP table, then SHOWRUNNER™ will automatically configure the IP-ID for each ZUMNET-JBOX during discovery
50 50  1. Repeat from step 3 until all ZUMNET-JBOXs that are to be controlled by SHOWRUNNER™ have static IP addresses and unique CIDs for any hosted devices
51 -1. Connect to the processor in Toolbox and run the command: ##sr discover zumnet true false##
51 +1. Disconnect from any ZUMNET-JBOXs and then connect to the processor in Toolbox
52 +1. Run the command: ##sr discover zumnet true false##
52 52  1*. This command tells SHOWRUNNER™ to discover all ZUMMNET-JBOXs on the network, configure their IP tables, and then add corresponding areas and loads to the configuration
53 53  1*. One area will be created per ZUMNET-JBOX
54 54  1. Run the command: ##sr discover zumnet true true##