Skip to Content

Changes for page Zūm Discovery

Last modified by Austin Weygandt on 2025/05/02 20:21
From version 41.1
edited by Austin Weygandt
on 2025/05/02 20:21
Change comment: There is no comment for this version
To version 40.1
edited by Alexander Mott
on 2025/04/03 17:35
Change comment: There is no comment for this version

Summary

Details

Page properties
Author
... ... @@ -1,1 +1,1 @@
1 -XWiki.austin\.weygandt@chiefintegrations\.com
1 +XWiki.alexander\.mott@chiefintegrations\.com
Content
... ... @@ -140,7 +140,6 @@
140 140  
141 141  (% class="box warningmessage" %)
142 142  (((
143 -* **Newer GWEXER firmware enables SSL by default. Follow the instructions at [[SSL User Configuration>>doc:SHOWRUNNER™ User Guide & Wiki.SHOWRUNNER™ Appendix.SSL User Configuration.WebHome]] and manually add the IP Table entries on the GWEXER**
144 144  * Processor with ShowRunnerCLC™ version 2.190 or newer must be running on the same network as the gateway(s) to be acquired
145 145  ** For ShowRunnerCLC™ versions prior to 3.014 and newer, replace **##sr discover zummesh##** commands with **##sr discover zum##**
146 146  * ZUM-NETBRIDGES must already be acquired to their respective gateway
... ... @@ -147,6 +147,7 @@
147 147  * ShowRunnerCLC™ will automatically address any ZUM-NETBRIDGES that do not need have addresses assigned, but will still honor any already addressed devices
148 148  * Disconnect from any RF gateways you may be connected to in Toolbox prior to running the discovery command
149 149  * Plug loads will not appear in the ShowRunnerCLC™ UI
149 +* Newer GWEXER firmware enables SSL by default. Follow the instructions at [[SSL User Configuration>>doc:SHOWRUNNER™ User Guide & Wiki.SHOWRUNNER™ Appendix.SSL User Configuration.WebHome]] and manually add the IP Table entries on the GWEXER
150 150  )))
151 151  
152 152  (% class="box infomessage" id="HCaution:" %)