Skip to Content

Changes for page Zūm Discovery

Last modified by Alexander Mott on 2025/04/03 17:35
From version 24.2
edited by Craig Lewis
on 2024/05/22 21:45
Change comment: There is no comment for this version
To version 26.1
edited by Craig Lewis
on 2024/05/29 15:37
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -30,6 +30,7 @@
30 30  * Zūm Wired firmware .puf version 1.02.10 or greater required (ZUMNET-JBOX installed minimum version 1.001.00081)
31 31  * Disconnect from any ZUMNET devices you may be connected to in Toolbox prior to running the discovery commands
32 32  * Cresnet devices landed on Zūm Link will not be discovered (Crestron bug expected to be corrected in a future firmware release)
33 +* ZUMLINK-KPs will not be discovered (Expected to be discoverable in future release)
33 33  * One area will be created per ZUMNET-JBOX; if there are more areas than ZUMNET-JBOXs, additional areas must be created manually
34 34  )))
35 35  
... ... @@ -51,7 +51,8 @@
51 51  1**. configure keypad logic
52 52  1**. configure occupancy sensor settings
53 53  1**. calibrate photocell(s)
54 -1*. Set hostnames for the ZUMNETs for easy identification when hardware is discovered.
55 +1*. Set hostnames for the ZUMNETs.
56 +1**. Zūm discovery will bring in hostnames.
55 55  1. Unique Connection IDs should be automatically assigned to any Zūm Link and Cresnet devices on the ZUMNET-JBOX
56 56  1*. If firmware was out-of-date, then this step should have already been completed
57 57  1*. If unique CIDs are not automatically assigned, connect to the JBOX in Toolbox and give the devices unique CIDs