Skip to Content

Changes for page Zūm Discovery

Last modified by Alexander Mott on 2025/04/03 17:35
From version 24.2
edited by Craig Lewis
on 2024/05/22 21:45
Change comment: There is no comment for this version
To version 24.1
edited by Alexander Mott
on 2024/01/05 18:49
Change comment: Renamed back-links.

Summary

Details

Page properties
Author
... ... @@ -1,1 +1,1 @@
1 -XWiki.craig\.lewis@chiefintegrations\.com
1 +XWiki.alexander\.mott@chiefintegrations\.com
Content
... ... @@ -46,12 +46,7 @@
46 46  1*. Load the Zūm Wired firmware to the ZUMNET-JBOX
47 47  1*. Repeat the above steps for all ZUMNET-JBOXs
48 48  1*. Once all the ZUMNET-JBOXs have pushed the new firmware to their hosted devices, disconnect from them in Toolbox and proceed to the next step
49 -1. Connect to each ZUMNET-JBOX in the Crestron Zūm App
50 -1*. Commission room through the app
51 -1**. configure keypad logic
52 -1**. configure occupancy sensor settings
53 -1**. calibrate photocell(s)
54 -1*. Set hostnames for the ZUMNETs for easy identification when hardware is discovered.
49 +1. Connect to first ZUMNET-JBOX in the Crestron Zūm App
55 55  1. Unique Connection IDs should be automatically assigned to any Zūm Link and Cresnet devices on the ZUMNET-JBOX
56 56  1*. If firmware was out-of-date, then this step should have already been completed
57 57  1*. If unique CIDs are not automatically assigned, connect to the JBOX in Toolbox and give the devices unique CIDs