Skip to Content

Changes for page Zūm Discovery

Last modified by Alexander Mott on 2025/04/03 17:35
From version 24.1
edited by Alexander Mott
on 2024/01/05 18:49
Change comment: Renamed back-links.
To version 24.2
edited by Craig Lewis
on 2024/05/22 21:45
Change comment: There is no comment for this version

Summary

Details

Page properties
Author
... ... @@ -1,1 +1,1 @@
1 -XWiki.alexander\.mott@chiefintegrations\.com
1 +XWiki.craig\.lewis@chiefintegrations\.com
Content
... ... @@ -46,7 +46,12 @@
46 46  1*. Load the Zūm Wired firmware to the ZUMNET-JBOX
47 47  1*. Repeat the above steps for all ZUMNET-JBOXs
48 48  1*. Once all the ZUMNET-JBOXs have pushed the new firmware to their hosted devices, disconnect from them in Toolbox and proceed to the next step
49 -1. Connect to first ZUMNET-JBOX in the Crestron Zūm App
49 +1. Connect to each ZUMNET-JBOX in the Crestron Zūm App
50 +1*. Commission room through the app
51 +1**. configure keypad logic
52 +1**. configure occupancy sensor settings
53 +1**. calibrate photocell(s)
54 +1*. Set hostnames for the ZUMNETs for easy identification when hardware is discovered.
50 50  1. Unique Connection IDs should be automatically assigned to any Zūm Link and Cresnet devices on the ZUMNET-JBOX
51 51  1*. If firmware was out-of-date, then this step should have already been completed
52 52  1*. If unique CIDs are not automatically assigned, connect to the JBOX in Toolbox and give the devices unique CIDs