Skip to Content

Changes for page Site Readiness Checklist

Last modified by Alexander Mott on 2024/12/02 17:25
From version 4.1
edited by Alexander Mott
on 2024/12/02 17:25
Change comment: There is no comment for this version
To version 3.1
edited by Alexander Mott
on 2023/06/27 16:53
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -7,14 +7,10 @@
7 7  * Networked control hardware (Cresnet and Zūm Wired devices) should be installed per the submittals
8 8  * Ethernet runs between control and HUB panels should be complete and terminated at the panels
9 9  * Serial numbers for installed devices should be collected and provided to the technician prior to arriving on-site
10 -* If applicable, building LAN should be up and running and you should be provided all the information required to correctly configure the lighting control devices, including:
11 -** Specific IP addresses or an IP address range for the lighting control system
12 -** Subnet mask
13 -** Default gateway/router IP address
14 -** Any specific hostnames required
10 +* If applicable, building LAN should be up and running
15 15  * All Crestron hardware (processor panels, HUB panels, and load controllers) should be powered up and remain powered up
16 16  * All loads (fixtures) should be landed at load controlling modules according to the load schedule in the submittals
17 -** All loads should be powered up and verified that there are no shorts or tripped breakers 
13 +** All loads should be powered up and verified that there are no shorts or tripped breakers
18 18  ** Certain load controllers, such as CLX modules, will need the terminal jumpers removed prior to load verification
19 19  ** Loads should be tested to ensure that they are controlled by the correct modules and outputs
20 20  *** Most 0-10V modules have local buttons which can be used to test dimming and switching