Last modified by Alexander Mott on 2023/12/13 19:15
From version 11.1
edited by Alexander Mott
on 2023/03/29 21:57
Change comment: There is no comment for this version
To version 12.1
edited by Alexander Mott
on 2023/03/29 22:41
Change comment: Uploaded new attachment "1680129701821-479.png", version {1}

Summary

Details

Page properties
Content
... ... @@ -79,5 +79,8 @@
79 79  The steps for statically configuring a networked Zūm Wired installation with SHOWRUNNER™ are:
80 80  
81 81  1. [[Configure the static IP address>>doc:SHOWRUNNER™ Setup Guide.SHOWRUNNER™ Installation Guide.SHOWRUNNER™ Installation and Network Setup.Processor Setup.WebHome||anchor="HIPConfiguration"]] for the processor and [[install SHOWRUNNER™>>doc:SHOWRUNNER™ Setup Guide.SHOWRUNNER™ Installation Guide.SHOWRUNNER™ Installation and Network Setup.Processor Setup.WebHome||anchor="HProgramLoad"]]
82 -1. [[dhcp>>doc:SHOWRUNNER™ Setup Guide.Troubleshooting Guide.Advanced Tools.DHCP Server.WebHome]]
82 +1. Use SHOWRUNNER™'s built in [[DHCP server>>doc:SHOWRUNNER™ Setup Guide.Troubleshooting Guide.Advanced Tools.DHCP Server.WebHome]]
83 +** If it you want to use specific static IP addresses for specific ZUMNET-JBOXs, use the SHOWRUNNER™ UI and set the DHCP range outside of the range you intend to use for the ZUMNET-JBOXs
84 +** If arbitrary static IP addresses are acceptable, then use the default IP address range
85 +1. Proceed with the standard [[CNET Mode>>doc:Hardware Design Guide.Crestron Zum Wired.Starting Up Zum Wired with SHOWRUNNER.WebHome||anchor="HIPConfiguration"]] start-up procedure
83 83  )))
1680129701821-479.png
Author
... ... @@ -1,0 +1,1 @@
1 +XWiki.alexander\.mott@chiefintegrations\.com
Size
... ... @@ -1,0 +1,1 @@
1 +6.8 KB
Content