Skip to Content
Last modified by Alexander Mott on 2023/12/08 18:37
From version 14.11
edited by Alexander Mott
on 2023/03/27 19:33
Change comment: (Autosaved)
To version 14.12
edited by Alexander Mott
on 2023/03/27 19:37
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -101,12 +101,15 @@
101 101  ** ZUMNET-JBOX-* devices must be manually set to Zūm App mode
102 102  ** ZUMNET-JBOX-* devices must be manually set to Primary mode
103 103  ** Updating firmware with the Crestron Zūm App is not possible with out-of-the-box firmware and must be initially done through Toolbox
104 -* ZUMNET-JBOX-* devices can only be connected to and configured via the App if there is a ZUMLINK-KP on their Zūm Link bus. During start-up, a technician must bring a ZUMLINK-KP with them to connect to the ZUMNET-JBOX for any rooms that were not designed to have a ZUMLINK-KP
104 +* ZUMNET-JBOX-* devices can only be connected to and configured via the App if there is a ZUMLINK-KP on their Zūm Link bus
105 +** During start-up, a technician must bring a ZUMLINK-KP to connect to the ZUMNET-JBOX in order to configure any rooms that were designed without a ZUMLINK-KP
105 105  * No scheduling capabilities
106 106  * No cross-room control capabilities (i.e., ZUMLINK-* keypads and occupancy sensors are restricted to controlling loads that are attached to the same ZUMNET-JBOX as they are)
107 107  * No support for Cresnet devices
108 108  * No support for third-party integrations beyond the override contact-closure relay at each ZUMNET/ZUMLINK-JBOX and the relay output of any *-RLY model occupancy sensors
109 109  * No support for DMX control
111 +* No possibility for remote support or management, as the only way to connect to any of the devices is by being using the Zūm App, which requires being within Bluetooth range of the device
112 +* Potential security concerns if the default PINs are not changed during start-up
110 110  
111 111  == Networked ==
112 112