Skip to Content
Last modified by Alexander Mott on 2023/12/08 18:37
From version 10.8
edited by Alexander Mott
on 2023/03/24 18:52
Change comment: (Autosaved)
To version 10.9
edited by Alexander Mott
on 2023/03/24 18:57
Change comment: (Autosaved)

Summary

Details

Page properties
Content
... ... @@ -22,10 +22,17 @@
22 22  
23 23  == Primary vs Secondary Mode ==
24 24  
25 -ZUMNET-JBOX-* devices can be set to be either the primary room controller or a secondary load controller.
25 +(% class="box infomessage" %)
26 +(((
27 +Note that prior to .puf firmware v1.03.27 (device firmware v1.002.00026), these were referred to as "master" and "slave" mode. As of February, 2023, ZUMNET-JBOX-* are still shipping on this older firmware, and so the older commands must be used to initially change the mode prior to updating device firmware.
28 +)))
26 26  
27 -Note that on older versions of firmware, these modes were referred to as "master" and "slave" mode. The terminology was updated in .puf v1.03.27 (device firmware v1.002.00026), but as of February, 2023 the FW
30 +ZUMNET-JBOX-* devices can be set to be either the primary room controller or a secondary load controller. As of February, 2023, ZUMNET-JBOX-*
28 28  
32 +* In Primary
33 +
34 +While in secondary mode, the ZUMNET-JBOX-* acts as if it were cannot detect any devices on its
35 +
29 29  == Security ==
30 30  
31 31  Lorem