Skip to Content
Last modified by Alexander Mott on 2023/12/08 18:37
From version 10.6
edited by Alexander Mott
on 2023/03/24 18:42
Change comment: (Autosaved)
To version 10.8
edited by Alexander Mott
on 2023/03/24 18:52
Change comment: (Autosaved)

Summary

Details

Page properties
Content
... ... @@ -6,14 +6,14 @@
6 6  (((
7 7  Crestron Zūm Wired is a distributed lighting control system that has various global and local control options. Zūm Wired uses industry standard dimming protocols (DALI, 0-10V, and phase dimming) and advanced sensors to provide automated control of a building or facility's lighting. With certain designs, it is also possible to integrate control over DMX fixtures, building management systems, and other third-party devices (such as motorized shades and HVAC).
8 8  
9 -The purpose of this article is to explain
9 +The purpose of this article is to explain various important concepts that must be understood in order to design a system that meets the requirements of all project stakeholders.
10 10  
11 += System Overview and Hardware Modes =
11 11  
13 +Zūm Wired systems consist of ZUMNET-JBOX-* room controllers and a number of connected ZUMLINK-* devices. ZUMLINK-* devices can be ZUMLINK-JBOX-* load controllers, ZUMLINK-OCC-* presence detectors, or ZUMLINK-KP-R-W keypads (wall switches). ZUMNET-JBOX-* and ZUMLINK-JBOX-* devices have additional inputs for third-party presence detectors, 0-10V analog photocells, and contact-closure local override.
12 12  
13 -the various control paradigms available with Zūm Wired and the different modes that Zūm Wired devices can be operated in, and the impacts on the system's capabilities that must be cons
15 +== App Mode ==
14 14  
15 -= ZUMNET-JBOX Hardware Modes =
16 -
17 17  Lorem
18 18  
19 19  == CNET Mode ==
... ... @@ -20,14 +20,12 @@
20 20  
21 21  Lorem
22 22  
23 -== App Mode ==
23 +== Primary vs Secondary Mode ==
24 24  
25 -Lorem
25 +ZUMNET-JBOX-* devices can be set to be either the primary room controller or a secondary load controller.
26 26  
27 -== Primary vs Secondary ==
27 +Note that on older versions of firmware, these modes were referred to as "master" and "slave" mode. The terminology was updated in .puf v1.03.27 (device firmware v1.002.00026), but as of February, 2023 the FW
28 28  
29 -Lorem
30 -
31 31  == Security ==
32 32  
33 33  Lorem