Skip to Content
Last modified by Alexander Mott on 2023/12/08 18:37
From version 10.5
edited by Alexander Mott
on 2023/03/24 18:37
Change comment: (Autosaved)
To version 10.9
edited by Alexander Mott
on 2023/03/24 18:57
Change comment: (Autosaved)

Summary

Details

Page properties
Content
... ... @@ -6,15 +6,14 @@
6 6  (((
7 7  Crestron Zūm Wired is a distributed lighting control system that has various global and local control options. Zūm Wired uses industry standard dimming protocols (DALI, 0-10V, and phase dimming) and advanced sensors to provide automated control of a building or facility's lighting. With certain designs, it is also possible to integrate control over DMX fixtures, building management systems, and other third-party devices (such as motorized shades and HVAC).
8 8  
9 -The purpose of this article is to
9 +The purpose of this article is to explain various important concepts that must be understood in order to design a system that meets the requirements of all project stakeholders.
10 10  
11 -(% class="box warningmessage" %)
12 -(((
13 -Add more to intro
14 -)))
11 += System Overview and Hardware Modes =
15 15  
16 -= Hardware Modes =
13 +Zūm Wired systems consist of ZUMNET-JBOX-* room controllers and a number of connected ZUMLINK-* devices. ZUMLINK-* devices can be ZUMLINK-JBOX-* load controllers, ZUMLINK-OCC-* presence detectors, or ZUMLINK-KP-R-W keypads (wall switches). ZUMNET-JBOX-* and ZUMLINK-JBOX-* devices have additional inputs for third-party presence detectors, 0-10V analog photocells, and contact-closure local override.
17 17  
15 +== App Mode ==
16 +
18 18  Lorem
19 19  
20 20  == CNET Mode ==
... ... @@ -21,14 +21,19 @@
21 21  
22 22  Lorem
23 23  
24 -== App Mode ==
23 +== Primary vs Secondary Mode ==
25 25  
26 -Lorem
25 +(% class="box infomessage" %)
26 +(((
27 +Note that prior to .puf firmware v1.03.27 (device firmware v1.002.00026), these were referred to as "master" and "slave" mode. As of February, 2023, ZUMNET-JBOX-* are still shipping on this older firmware, and so the older commands must be used to initially change the mode prior to updating device firmware.
28 +)))
27 27  
28 -== Primary vs Secondary ==
30 +ZUMNET-JBOX-* devices can be set to be either the primary room controller or a secondary load controller. As of February, 2023, ZUMNET-JBOX-*
29 29  
30 -Lorem
32 +* In Primary
31 31  
34 +While in secondary mode, the ZUMNET-JBOX-* acts as if it were cannot detect any devices on its
35 +
32 32  == Security ==
33 33  
34 34  Lorem