Skip to Content
Last modified by Alexander Mott on 2023/12/08 18:37
From version 10.11
edited by Alexander Mott
on 2023/03/24 19:07
Change comment: (Autosaved)
To version 10.8
edited by Alexander Mott
on 2023/03/24 18:52
Change comment: (Autosaved)

Summary

Details

Page properties
Content
... ... @@ -22,18 +22,10 @@
22 22  
23 23  == Primary vs Secondary Mode ==
24 24  
25 -(% class="box infomessage" %)
26 -(((
27 -Note: the terminology used for these modes was modified in .puf firmware v1.03.27 (device firmware v1.002.00026). Hardware delivered with older firmware will require the use of different commands to change modes during start-up.
28 -)))
25 +ZUMNET-JBOX-* devices can be set to be either the primary room controller or a secondary load controller.
29 29  
30 -ZUMNET-JBOX-* devices can be set to be either the Primary room controller or a Secondary load controller. There must only be one Primary ZUMNET-JBOX on a given Zūm Link bus, and in a networked system the Primary ZUMNET-JBOX is the one that should be connected to the Zūm Net. Secondary mode.
27 +Note that on older versions of firmware, these modes were referred to as "master" and "slave" mode. The terminology was updated in .puf v1.03.27 (device firmware v1.002.00026), but as of February, 2023 the FW
31 31  
32 -* In Primary mode, the ZUMNET-JBOX acts as the Zūm Link host, and is able to detect all connected Zūm Link devices when connected to over Zūm Net in Crestron Toolbox. If also in App mode, a ZUMNET-JBOX in Primary mode will be the logical room controller for the space, and is the device that will be connected to via the Zūm App for configuration.
33 -* In Secondary mode, the ZUMNET-JBOX acts as if it were a ZUMLINK-JBOX
34 -
35 -As of February, 2023, all ZUMNET-JBOX-* devices ship preconfigured in Secondary mode,
36 -
37 37  == Security ==
38 38  
39 39  Lorem