Skip to Content
Last modified by Alexander Mott on 2023/12/08 18:37
From version 10.10
edited by Alexander Mott
on 2023/03/24 19:02
Change comment: (Autosaved)
To version 10.9
edited by Alexander Mott
on 2023/03/24 18:57
Change comment: (Autosaved)

Summary

Details

Page properties
Content
... ... @@ -24,7 +24,7 @@
24 24  
25 25  (% class="box infomessage" %)
26 26  (((
27 -Note: the terminology used for these modes was modified in .puf firmware v1.03.27 (device firmware v1.002.00026). Hardware delivered with older firmware will require the use of different commands to change modes during start-up.
27 +Note that prior to .puf firmware v1.03.27 (device firmware v1.002.00026), these were referred to as "master" and "slave" mode. As of February, 2023, ZUMNET-JBOX-* are still shipping on this older firmware, and so the older commands must be used to initially change the mode prior to updating device firmware.
28 28  )))
29 29  
30 30  ZUMNET-JBOX-* devices can be set to be either the primary room controller or a secondary load controller. As of February, 2023, ZUMNET-JBOX-*