Skip to Content
Last modified by Alexander Mott on 2023/12/08 18:37
From version 10.10
edited by Alexander Mott
on 2023/03/24 19:02
Change comment: (Autosaved)
To version 10.5
edited by Alexander Mott
on 2023/03/24 18:37
Change comment: (Autosaved)

Summary

Details

Page properties
Content
... ... @@ -6,14 +6,15 @@
6 6  (((
7 7  Crestron Zūm Wired is a distributed lighting control system that has various global and local control options. Zūm Wired uses industry standard dimming protocols (DALI, 0-10V, and phase dimming) and advanced sensors to provide automated control of a building or facility's lighting. With certain designs, it is also possible to integrate control over DMX fixtures, building management systems, and other third-party devices (such as motorized shades and HVAC).
8 8  
9 -The purpose of this article is to explain various important concepts that must be understood in order to design a system that meets the requirements of all project stakeholders.
9 +The purpose of this article is to
10 10  
11 -= System Overview and Hardware Modes =
11 +(% class="box warningmessage" %)
12 +(((
13 +Add more to intro
14 +)))
12 12  
13 -Zūm Wired systems consist of ZUMNET-JBOX-* room controllers and a number of connected ZUMLINK-* devices. ZUMLINK-* devices can be ZUMLINK-JBOX-* load controllers, ZUMLINK-OCC-* presence detectors, or ZUMLINK-KP-R-W keypads (wall switches). ZUMNET-JBOX-* and ZUMLINK-JBOX-* devices have additional inputs for third-party presence detectors, 0-10V analog photocells, and contact-closure local override.
16 += Hardware Modes =
14 14  
15 -== App Mode ==
16 -
17 17  Lorem
18 18  
19 19  == CNET Mode ==
... ... @@ -20,19 +20,14 @@
20 20  
21 21  Lorem
22 22  
23 -== Primary vs Secondary Mode ==
24 +== App Mode ==
24 24  
25 -(% class="box infomessage" %)
26 -(((
27 -Note: the terminology used for these modes was modified in .puf firmware v1.03.27 (device firmware v1.002.00026). Hardware delivered with older firmware will require the use of different commands to change modes during start-up.
28 -)))
26 +Lorem
29 29  
30 -ZUMNET-JBOX-* devices can be set to be either the primary room controller or a secondary load controller. As of February, 2023, ZUMNET-JBOX-*
28 +== Primary vs Secondary ==
31 31  
32 -* In Primary
30 +Lorem
33 33  
34 -While in secondary mode, the ZUMNET-JBOX-* acts as if it were cannot detect any devices on its
35 -
36 36  == Security ==
37 37  
38 38  Lorem